Publications

Numerical modeling of the interaction between waves and coastal structures is a challenge due to the many nonlinearphenomena involved, such as wave propagation, wave transformation with water depth, interaction between incident andreflected waves, runup/rundown and wave overtopping. For simulating such complex free-surface flows, numerical modelsbased on Lagrangian formulation, such as Smoothed Particle Hydrodynamics (SPH), are on option. Even though validationof these numerical models is essential, comparing numerical results with experimental data is not an easy task. In thepresent paper, an SPH numerical model is validated comparing numerical results of waves interacting with a compositebreakwater with data obtained from physical model tests carried out in one of the LNEC

Groins are cross shore structures built to promote shoreline stabilization. However, the specific impact of these structures on the wave conditions and velocity field nearshore (and hence, on sediment transport) is still poorly understood. Therefore, this study wishes to extend this knowledge using a numerical model, COULWAVE, previously validated with field data. For that, a typical bar-trough profile is considered and different groin lengths and orientations are tested, under the influence of different significant incident-wave heights and sea-surface levels.The hydrodynamics factors are found to have a greater impact on the nearshore wave conditions than the groin geometry. The variation of significant incident-wave height imparts the greater changes in wave height nearshore, where the groin would be located. The typical tidal range is also important, since a 2 m change in sea surface level can cause great depth changes over bathymetric features and thus influence wave propagation. Although less important, the geometry of the groin should also be considered. The greater the length, the greater the sheltering effect expected, extending further to the lee-side of the groin. The impact will also reach a broader region. With a smaller impact verified, the best orientation of the groin is hard to unravel.

The study of ways of converting ocean wave energy into a useful one and the improvement of theexisting equipment are complex engineering problems and very important issues in today

The length of the Portuguese coast, the severity of the sea conditions and the concentration of population and economic activities on its coastal zone justify the importance of studying wave-induced risks and, in particular, flooding due to wave action. Indeed, emergency situations caused by adverse sea conditions are frequent and put in danger the safety of people and goods, with negative impacts for society, economy and natural heritage. So, assessing the risk of flooding of coastal and port areas is essential for the proper planning and management of these areas. In this framework, a methodology for the flood risk assessment in coastal and port areas is under development. The methodology is embedded into the HIDRALERTA system, a novel integrated system for port and coastal management, designed to prevent emergency situations, to support their management and to forecast incidental long-term interventions. The present paper describes the methodology, the HIDRALERTA system and a case study, the São João da Caparica beach, on the Lisbon

Para reducir la agitación en el interior del puerto de Vila do Porto, Azores, se ha proyectado una modificación del muelle interior de atraque de los ferries, con el objetivo de aminorar la reflexión y disminuir el rebase, sin que con eso se reduzca demasiado el área útil de la dársena portuaria. La solución propuesta es una plataforma de forma triangular en planta apoyada en pilares rectangulares, bajo la cual se ha colocado un talud de escollera para disminuir la reflexión. Se presentan los resultados de ensayos en modelo físico 3D y los obtenidos con dos modelos numéricos RANS en lo que se refiere a presiones en la plataforma y reducción de la reflexión (el modelo IH-2VOF y el FLUENT).

Submarine outfalls need to be evaluated as part of an integrated environmental protection system forcoastal areas. Although outfalls are tight with the diversity of economic activities along a denselypopulated coastline being effluent treatment and effluent reuse a sign of economic prosperity, precautionsmust be taken in the construction of these structures. They must be designed so as to have the leastpossible impact on the environment and at the same time be economically viable. This paper outlines theinitial phases of a risk assessment procedure for submarine outfall projects. This approach includesa cost-benefit analysis in which risks are systematically minimized or eliminated. The methods used inthis study also allow for randomness and uncertainty. The input for the analysis is a wide range ofinformation and data concerning the failure probability of outfalls and the consequences of an operationalstoppage or failure.As part of this risk assessment, target design levels of reliability, functionality, and operationality weredefined for the outfalls. These levels were based on an inventory of risks associated with suchconstruction projects, and thus afforded the possibility of identifying possible failure modes. Thisassessment procedure was then applied to four case studies in Portugal. The results obtained were thevalues concerning the useful life of the outfalls at the four sites and their joint probability of failureagainst the principal failure modes assigned to ultimate and serviceability limit states. Also defined werethe minimum operationality of these outfalls, the average number of admissible technical breakdowns,and the maximum allowed duration of a stoppage mode. It was found that these values were inconsonance with the nature of the effluent (tourist-related, industrial, or mixed) as well as its importancefor the local economy. Even more important, this risk assessment procedure was able to measure theimpact of the outfalls on human health and the environment.

Neste artigo descreve-se a ferramenta numérica SWAMS que se baseia nos modelosnuméricos DREAMS, BOUSS-WMH e MOORNAV para caracterizar a resposta dum navioamarrado no interior dum porto sujeito à acção da agitação marítima. Os dois primeirosmodelos simulam a propagação de ondas lineares e não lineares em zonas abrigadas deprofundidade variável, tendo em conta os fenómenos da refracção, difracção, reflexãoparcial, dissipação de energia devida ao atrito de fundo e rebentação das ondas. Enquantoo modelo DREAMS é um modelo linear baseado na equação de declive suave, o modelonão linear BOUSS-WMH é baseado nas equações de Boussinesq. O comportamento donavio amarrado é simulado com o pacote numérico MOORNAV que engloba um modelonumérico para resolver, no domínio da frequência, os problemas de radiação e de difraçãoda interacção de corpos flutuantes com ondas e um modelo que converte os resultadosdaqueles problemas do domínio do tempo para o domínio da frequência e que monta eresolve as equações do movimento do navio amarrado, BAS.Apresentam-se asmodificações introduzidas no modelo WAMIT para calcular as forças de difracção com basenas relações apresentadas em Haskind. Tais relações, porque utilizam o potencial develocidades obtido com o modelo DREAMS ou com o modelo BOUSS-WMH, permitemlevar em conta a refracção, difracção ou reflexão que podem ocorrer na propagação dasondas para o interior de uma bacia abrigada. Para além da descrição dos modelosnuméricos na ferramenta SWAMS, apresenta-se a forma como os resultados sãotransferidos entre eles bem como aplicações da mesma para ilustrar as suas capacidades.

The current study proposes prediction formulas both for random wave runup and mean overtopping discharge at seawalls constructedon land or in very shallow water. Although several existing formulas for runup and overtopping use the incident wave characteristicsat the toes of seawalls, this study adopts the equivalent deepwater wave characteristics and an imaginary seawall slope for easy application of theformulas, especially in relation to seawalls constructed on land. The prediction formulas for overtopping use the predicted runup values. For thewave runup prediction formulas two sets of experimental data are used; i.e., a new set of data and the data obtained in a previous study. For thewave overtopping prediction formulas, the experimental data measured in a previous study are used. Comparisons with measurements showgood performances of both new prediction methods.

This paper presents the new boundary condition implemented in the LNEC SPH numerical model based on theSPHysics model and on a standard Smoothed Particle Hydrodynamic formulation: the piston-type wave maker includesnow dynamic wave absorption and allows simulating a semi-infinite flume. Verification of the active wave makerabsorption is carried out through the simulation of the interaction between a regular incident wave and an impermeablevertical breakwater. Results show that the active wave-maker allows outgoing waves to be absorbed and reflection at thewave-maker to be avoided

Este artigo aborda a análise comparativa entre as medições de agitação marítima efectuadas na Praia da Cornélia (Costa da Caparica, Portugal), durante os dias 12 a 14 de Maio de 2010, e os resultados numéricos da aplicação do modelo não-linear do tipo Boussinesq, COULWAVE. Esta análise tem como principal objectivo a avaliação do desempenho deste modelo numérico na simulação da propagação de ondas em condições reais, pretendendo evidenciar, deste modo, as suas potencialidades e limitações.As condições de fronteira do modelo foram geradas com base em séries temporais de elevação medidas a uma profundidade aproximada de 7.6 m (relativa ao zero hidrográfico

The ultimate goal of applying SWASH in the present work is to compare SWASH wave height results with laboratory results presented in Løvås (2000) and with field observations of Vo-Luong and Massel (2008) as well. Additionally, SWASH results will be also compared to the ones previously obtained by other empirical and numerical models (Mendez and Losada, 2004; Suzuki et al., 2012).Preliminary SWASH wave height simulations for breaking random waves over vegetation have shown an overall good agreement to the flume data presented in Løvås (2000). The agreement between SWASH and flume results looked worst at the wave breaking zone, which seems to be improved through a better wave breaking parametrization.

Most of the previous studies on wave propagation over vegetation fields estimated drag coefficients (CD) for rigid and flexible plants by the so called calibration method which gave similar CD for both types of plants. However, CD may actually be considerably different when the drag force is directly measured. In order to investigate the wave dissipation and CD further, flume experiments for wave propagation over vegetation are conducted with a special focus on the benchmark single cylinder test that calculates CD by direct measurements in single rigid and flexible artificial plants.

O projeto BSafe4Sea visa desenvolver, testar e comprovar o conceito de previsão do comportamento estrutural de quebra-mares de talude como a base de um sistema inovador de apoio à decisão. A utilização de fotografias aéreas obtidas com veículos aéreos não tripulados, de vídeo e de posicionamento com GNSS, juntamente com a avaliação probabilística do comportamento dos quebra-mares baseada em modelos físicos e numéricos, apoiarão o planeamento e a priorização de trabalhos de manutenção e reparação, aumentando a segurança, funcionalidade e resiliência destas obras. Este sistema é urgente devido à sua relevância para as modernas redes de transporte de mercadorias e passageiros e às condições extremas a que os quebra-mares estão sujeitos, e que se poderão agravar devido às alterações climáticas.

This paper describes a programme under the responsibility of LNEC for the systematic observation and monitoring of maritime works that has successfully been applied to an extensive number of maritime structures on the Portuguese mainland coast and abroad.The now-called OSOM+ programme comprises the following four main components for each structure: periodic visual inspections by an experienced technician; periodic aerial inspections with a UAV/drone; a ANOSOM-GIS database, to store and/or query obtained information on the observation campaigns, as well as to diagnose present, evolution and risk conditions of the structure; a mobile, portable, application, for real-time input and visualization of the database information.This recently updated methodology encompasses a number of tools and functionalities that are illustrated in this paper with applications to a real case, the Faro-Olhão

In this paper, the development of such system, called SWAMS ALERT, is detailed and an illustration on how it applies to a real port is presented, namely the port of S. Roque do Pico. SWAMS ALERT is as risk forecast and management system for the safety of transiting ships and moored ships in ports and harbors. This system can be fine-tuned to a specific port, thus becoming a valuable tool to help in the selection of docking and mooring devices. SWAMS ALERT extends the functionality of the wave overtopping events forecast system HIDRALERTA to include the ship

Since 1986, the National Laboratory for Civil Engineering (LNEC) has developed a program for Systematic Observation of Maritime Works (OSOM) for the structures under the responsibility of the former Port and Maritime Transport Institute (IPTM).The objective of this program is to monitor the behavior of the structures and recommend timely interventions for their maintenance and/or repair. Recently, with the acquisition by LNEC of an unmanned aerial vehicle (UAV, or drone), a number of structural surveys have been carried out to complement the information obtained in above mentioned visual observation campaigns. The UAV provides more detailed and accurate information on the state of the structures. It also allows the assessment of the evolution of structures

Neste artigo descreve-se o trabalho desenvolvido, até ao presente na construção, desenvolvimento e implementação dos 2 novos protótipos do sistema HIDRALERTA para os portos da Madalena do Pico e de S. Roque do Pico, ambos na Ilha do Pico, Açores. Este sistema permite a previsão e alerta de situações de emergência relacionadas com agitação marítima, galgamentos, inundações.

The recent acquisition of an UAV (Unmanned Aerial Vehicle), or drone, has enriched ongoing LNEC

Nesta comunicação analisa-se a influência da variação da profundidade na interação hidrodinâmica entre dois navios, um estacionário e outro navegando na vizinhança, com recurso à modelação física e numérica. O navio em movimento é um modelo autopropulsionado à escala do navio de transporte de produtos químicos

O conhecimento das forças devido à ação das ondas que atuam nos emissários submarinos compostos por uma conduta e anéis de estabilização de betão, para agitação com direção de propagação próxima da direção do emissário, é essencial para o seu dimensionamento. Esta é uma configuração complexa, para a qual a modelação numérica, utilizando modelos 3D de tipo RANS-VoF (Reynolds-Average-Navier-Stokes Volume-of-Fluid), é especialmente adequada para obter uma estimativa das forças na conduta e nos anéis. O presente estudo consiste na simulação de um emissário submarino com anéis de estabilização à escala 1:15 que foi ensaiado num tanque de ondas tridimensional, nas instalações do Danish Hydraulics Institute (DHI), para estudar a influência da direção da agitação incidente e da distância da conduta ao fundo nas forças que atuam no emissário. Foram realizados ensaios sem e com anéis (2 tipos de anéis), para diferentes condições de agitação e direções de agitação incidente (90º, i.e., perpendicular à conduta, 30º e 10º) e para três distâncias da conduta ao fundo (0.0, 0.020 e 0.033m). Os resultados numéricos são comparados aos experimentais para agitação com direcção de propagação perpendicular ao emissário, para 3 alturas de onda incidente. Verificou-se que o modelo de turbulência k-

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A