Publications

O Porto de Leixões, localizado na costa norte de Portugal, é um dos maiores do país, recebendo diariamentevários navios de grandes dimensões. Um dos principais postos de acostagem situa-se à entrada do porto e encontra-se sujeito à agitação marítima que é difratada pelo olhe principal de proteção do porto. Para avaliar dos movimentos induzidos no navio estacionado nesse posto de acostagem e as forças exercidas nas suas amarras e defensas pela agitação incidente, utilizou-se o modelo físico de Leixões, construído num dos tanques do LNEC. Neste modelo físico, encontra-se representada a envolvente do porto de Leixões, assim como a sua batimetria. O modelo do navio

An alternative to the energy matrix expansion, due to the increase of global electricity demand, is the renewable sea wave energy source, which has high energy potential. The Oscillating Water Column (OWC) converter is one of the most studied, although it is not yet used at commercial scale. Therefore, searching the optimal geometric configuration is fundamental to turn this device viable. This study proposes a numerical analysis of an onshore OWC for different slopes of chamber walls (from 40o to 90o) and equipped with a Wells turbine. Simulations of incompressible 2D flows are performed by means of the FLUENT® software, which is based on Reynolds-averaged Navier-Stokes (RANS) equations. The k-

The most studied device used for extracting wave energy is the Oscillating Water Column (OWC). In general, numerical simulations of these cases by means of models based on Reynolds Averaged Navier-Stokes equations adopt the Volume of Fluid method to deal with the free surface flow which is considered incompressible in both water and air. The aim of this study is to investigate the influence of the compressibility effect on the air inside the OWC chamber by the FLUENT® numerical model. A methodology is implemented, taking into account both water and air flows incompressible, but, at every instant, a pressure condition is imposed on the top boundary of the chamber to consider the compressibility effect. This pressure condition is based on an analytical equation that considers the isentropic transformation of the air and effects of Wells and impulse turbines. Results of compressible and incompressible numerical models are compared. The amplification factor, the root mean square of air pressure inside the chamber and OWC efficiency in relation to incident wave period, wave height and turbine characteristic relation are analyzed. Results show that air compressibility effects can diminish the predicted OWC efficiency up to about 20% in both Wells and impulse turbines.

In this study, a numerical analysis of the performance of two Oscillating Water Column (OWC) wave energy converters, at different front and back wall slopes, was carried out. The first device had vertical front and back walls and the second one had its wall slopes of 40° in relation to the horizontal plane. The FLUENT® numerical model, which is based on the Reynolds-Averaged Navier-Stokes (RANS) equations, was used. The Volume of Fluid (VoF) method was employed to take into account free surface flows. The case study comprised a 10 m deep flume with an onshore OWC at its end, equipped with a Wells turbine. A 2D hydrodynamic mathematical model was employed and a 3D air pressure effect inside the OWC air-chamber was considered. Analyses of the hydrodynamics behavior, fluid-structure interaction outside (run-up/down, reflected waves) and inside the chamber (free surface elevation, sloshing) and energy distribution (pneumatic extracted energy, reflected wave energy and energy losses) were conducted. Results showed that the device with inclined walls had the best efficiency in comparison with the other one. However, the latter showed lower variation in efficiency in the wave period range than the former.

The main objective of this study is to investigate differences of random incident waves from regular ones in performance of wave energy converters (WEC). A numerical analysis of an onshore oscillating water column (OWC) WEC is carried out by means of the FLUENT® software, which is based on Reynolds - Averaged Navier-Stokes equations. Analyses of the efficiency of an onshore OWC device with similar characteristics of the Pico

Atualmente, mais importante que assegurar a resistência de um aglomerado urbano a um eventual invasor, importa garantir a sobrevivência a catástrofes naturais das infraestruturas críticas que garantem a salubridade das condições de vida nesse aglomerado, a mobilidade dos habitantes e o abastecimento de bens essenciais. Em rigor, face ao carater aleatório destas solicitações, pretende-se que, uma vez terminadas essas solicitações extremas, eventuais estragos causados pelas mesmas não impeçam o restabelecimento, em tempo útil, das atividades normais da população. Nesta comunicação apresentam-se ferramentas e procedimentos para avaliação do risco associado a infraestruturas críticas com um viés para o controlo de cheias urbanas e de infraestruturas de transporte marítimo.

The current program of Systematic Observation of Maritime Works (OSOM+), under development at the National Laboratory for Civil Engineering (LNEC), is essentially applied to rubble mound breakwaters. The OSOM

HIDRALERTA is a forecast and early warning system for coastal and port regions capable of predicting emergency situations, as well as carrying out risk assessment. The system concentrates on evaluating wave overtopping and flooding scenarios. It uses offshore sea-wave and wind forecast data, as well as tide data, as input to determine wave overtopping at specific locations. The calculation of the mean overtopping discharge over a structure is made through artificial neural network (ANN) tools and/or empirical formulae, which are able to define the spatial distribution of the flow behind the structure.The HIDRALERTA system is composed of four modules developed in Open Source Web Technology, mainly using the Python Language. The Warning System can be configured and adapted for specific scenarios. The system has been successfully tested for the Port and Bay of Praia da Vitória, Terceira Island, Azores, Portugal, and is now under development and being implemented at the ports of Madalena do Pico and S. Roque do Pico.This paper describes the work carried out to date on the system and its application to these two ports in the Pico Island, Azores.

A set of scale-model tests carried out to enlarge the range of wave steepness values analysed in run-up, overtopping and armour layer stability studies, focusing on oblique extreme wave conditions and on their effects on a gentler slope breakwater

Mechanical constraints have a non-negligible influence in the motion of oscillating wave surge converter (OWSC) devices. The key novelty of this paper is a numerical simulation tool for OWSCs that does not neglect or significantly compromise mechanical constraints such as hydraulic power take-off (PTO) system, revolute joints and frictional contacts among components. The paper is aimed at presenting the key components of the numerical simulation tool and at validating it with laboratory data featuring an OWSC with mechanical constraints under regular and irregular waves. It is based on the implementation of the multibody solver of Project Chrono under the Smoothed Particle Hydrodynamics (SPH) model of DualSPHysics, where the SPH solver resolves the interaction between wave and flap and the multibody solver resolves the interaction between flap and mechanical constraints. Comparison between numerical results and experimental data show that the numerical simulation tool properly predicts the dynamics of the OWSC. Furthermore, in what concerns hydrodynamics of the near-flap flow, the computed and measured free-surface elevations and phase-averaged flow field show reasonable agreement. Once properly validated, the numerical simulation tool is then applied to study the influence of several mechanical constraints, PTO damping characteristics and flap inertia on the hydrodynamic of the OWSC. The viability of OWSC design solutions based on the developed numerical simulation tool is emphasised, in view of its performance in the test cases to which it was subjected.

O objetivo do presente trabalho foi avaliar o desempenho da metodologia de análise de vídeo Timestack na estimativa do espraiamento e na identificação de eventos de galgamento em modelos físicos de quebra-mares de talude com manto resistente composto por cubos Antifer.No primeiro caso, foi avaliado o espraiamento num modelo físico tridimensional do quebra-mar de taludes, para condições de agitação com incidência frontal e oblíqua relativamente ao talude. No segundo caso, identificaram-se os eventos de galgamento considerando ensaios realizados num modelo físico bidimensional do quebra-mar de taludes. Todos os casos de teste realizados mostraram resultados muito satisfatórios, evidenciando a versatilidade da técnica.

Marginal protection structures or adherent longitudinal defenses, whose main function is to mitigate overtopping, are structures parallel to the coast. They are intended to serve as protection and shelter against flooding, due to overtopping, dissipating wave energy in their interaction with the structure, and in areas strongly affected by coastal erosion, minimizing the risk of damage to roads, walkways or buildings in the proximity.The evaluation of run-up and overtopping in marginal protection structures is determined according to the conditions of incident sea agitation and the characteristics of the structure, being fundamental for the design of new structures and in the verification of the safety of existing structures.

O SAFEPORT é um sistema de previsão e alerta de perigos associados a navegação dentro do Porto de Sines. Este documento apresenta uma aplicação deste sistema, mais especificamente, descreve a modelação numérica que permitiu simular o comportamento de três navios amarrados em três terminais do Porto de Sines, sob as condições de agitção marítima causadas pela tempestade Dora. Os alertas emitidos aos movimentos dos navios e às forças exercidas nos seus cabos de amarração permitiram concluir que o sistema SAFEPORT é capaz de prever e emitir alertas em situações potencialmente perigosas.

Damage progression in wave-exposed physical models of rubble-mound breakwaters can be assessed using two methods: traditional quantification of armor element movements or newer approaches involving non-intrusive surveys, utilizing photogrammetry, RGB sensors, Time of Flight depth sensors, and LiDAR laser scanning sensors to determine eroded volumes and depths between consecutive armor layer surveys. These techniques allow for the creation of three-dimensional surface models with varying accuracy, depending on survey conditions and post-processing methodologies. The performance, suitability, and usability of these techniques in assessing damage progression are comparatively evaluated. Furthermore, the advantages and disadvantages of each technique are identified, and a sensitivity analysis is presented for each one.

No âmbito do projeto das obras de expansão e requali

A avaliação da evolução dos danos causados pela agitação incidente em modelos físicos de quebra-mares de taludes pode ser efetuada através da quantificação de movimentos e quedas dos elementos do manto resistente (métodos tradicionais), ou pela determinação de volumes e profundidades erodidas entre levantamentos consecutivos dos respetivos taludes (métodos mais atuais). Para se efetuarem esses levantamentos dos taludes, podem aplicar-se técnicas fotogramétricas com sensores RGB, sensores de profundidade baseados na metodologia ToF (Time of Flight) e sensores de laser LiDAR (Light Detection And Ranging).No presente trabalho, aplicam-se essas técnicas ao modelo físico do quebra-mar do porto da Ericeira, que está presentemente a ser ensaiado no LNEC, e avalia-se, comparativamente, o respetivo desempenho, adequabilidade e usabilidade na determinação da evolução dos danos, identificando vantagens e desvantagens de cada uma destas técnicas.

A praia da Vagueira está localizada no Município de Vagos, distrito de Aveiro e é protegida por uma estrutura de defesa frontal aderente que foi requali

O projeto

A avaliação do dano causado pela agitação incidente em modelos físicos de quebra mares de taludes pode ser realizada comparando volumes e profundidades erodidas entre levantamentos consecutivos de cada talude. Atualmente, estes levantamentos podem ser realizados de forma não intrusiva, recorrendo a técnicas fotogramétricas, a laser scan ou a sensores de posição baseados na metolodologia Time of Flight (ToF). Dependendo das condições de levantamento e da metodologia de pós-processamento das nuvens de pontos obtidas, estas técnicas permitem obter modelos tridimensionais de superfície, com elevada precisão.

This paper presents the prototype of HIDRALERTA for the port of Aveiro, showing the potential of the system, both as a tool for forecasting and warning of emergency situations and as a tool for planning and managing the risk in climate change scenarios. The prototype for Aveiro harbour showcases a new feature of HIDRALERTA system, which is the early warning system for maneuvering ships along the entrance channel, following the work of the BlueSafePort project.

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A

N/A